Libvirt Guest Receives Dadfailed On All Ipv6
Hi,
I have a CentOS7 host with libvirt, attempting to boot a CentOS7 guest. I am attempting to do the install over ipv6 (because why not).
I have the following network configuration.
Cisco 3550 gi0/1 <-> eno1 (CentOS7) host.
gi0/1 is configured as:
switchport trunk encapsulation dot1q switchport trunk allowed vlan 1-17
switchport mode trunk
Mainly in question is vlan11 as this is the network I am trying to work with.
The switch have vlan11 configured with STP:
# sh spa v 11
VLAN0011
Spanning tree enabled protocol rstp
Root ID Priority 12299
Address 000c.30d1.9700
This bridge is the root
Hello Time 2 sec Max Age 10 sec Forward Delay 5 sec
Bridge ID Priority 12299 (priority 12288 sys-id-ext 11)
Address 000c.30d1.9700
Hello Time 2 sec Max Age 10 sec Forward Delay 5 sec
Aging Time 300
Interface Role Sts Cost Prio.Nbr Type
——————- —- — ——— ——
Recent Comments