Network Automatically Connecting On Boot After New Service Installation
2 weeks ago, i had my internet service changed from copper DSL to fiber DSL.
now, every time i reboot, internet connection is automatically connecting on boot.
before last update to 6.6, i could configure connection, now i can not bring up configuration window to disable auto connect.
because of uneasy feelings about leaving computer up when i leave home, i disconnect ‘bell line’ so that when i am gone and have a mains failure and ups shuts down, i will not have internet connected when mains restore.
also makes for uneasy feeling when retiring for night. :-)
what do i have to do to change this?
any and all replies / suggestions greatly appreciated. tia.
4 thoughts on - Network Automatically Connecting On Boot After New Service Installation
my DSL is delivered as an ethernet connection, there’s nothing to connect or disconnect, although I suppose I could use ifconfig eth0 up and ifconfig eth0 down
If you use Network Manager, just right-click on the little doodad in your panel bar and un-check “Enable networking”. When you want to re-connect, right-click on the little doodad and check “Enable networking”.
This will work regardless of whether your computer is hooked up with a wireless or wired ethernet connection.
hello John. my thanks for replying.
failed to mention the modem i have is a 2Wire 3800HGV-B.
connections, top down are;
Auxline – Lines 1&2 – Phone Line – Broadband –
Local Ether Net 1, 2, 3, 4 – USB-PC – Coaxline – Power
input is via Phone Line, Broadband, or Coaxline. rest are outputs. except for Power. ;-)
instead of using ‘ifconfig’, i have a network icon in ‘system tray’. see my reply to Frank Cox.
hi Frank. thank you for replying.
well, i guess i have ‘Network Manager’ if it is the network icon, aka,
“doodad”, in the system tray. but it does not give config menu in center of screen as i used to see.
your reply got my ‘chemo brain’ to thinking again about what is presented for right-click.
with right-click, a settings menu pops up with;
[ ] Enable Networking
[ ] Enable Wireless
[ ] Enable Notifications
(i) Connection Information {grayed out}
[ ] Edit Connections
(i) About
Enable Networking and Enable Wireless must be checked to enable either when icon is left-clicked and network _will_auto_connect_ after reboot.
if both are unchecked, left-click activates a grayed notice of
‘Networking disabled’ and network _will_not_auto_connect_ after reboot.
if only it would with out auto connect on reboot.
thanks again for reply. open to more suggestions.