Adding Kmod To Pxe Install
Hey guys,
I’m stumped in how to add the kmod rpm to pxe install. I need it to be installed but also loaded during the install as well. The rpm in question is the 3w-9xxx from elrepo https://CentOS.pkgs.org/8/elrepo-x86_64/kmod-3w-9xxx-2.26.02.014-1.el8_0.elrepo.x86_64.rpm.html
I’m constantly getting the following message Warning: can’t find installer main image path in .treeinfo
Any help or pointing in right direction would be appreciated.
Regards, Alex
4 thoughts on - Adding Kmod To Pxe Install
If you need it at install time, you need a dud (Driver Disk), so see http://mirrors.coreix.net/elrepo/dud/el8/x86_64/ and use inst.dd=
Thank you, Fabian! I too may need it in close future.
Valeri
Hopefully it’s obvious, but make sure you pick the driver update disk image that matches the kernel/point release you are installing (e.g, el8_0 or el8_1 etc).
<https://lists.CentOS.org/mailman/listinfo/CentOS>
Thanks a lot guys.